Handing can be redone by removing the battery pack, holding the program button for 10 seconds then reinserting the battery pack and then pressing the program button again
Read MoreThis is a feature to ensure door is always locked and the key is removed only in the locked position (vertical).
Read MoreALERT: A feature for property managers. If the turnpiece is disabled, the lock will always auto-lock after each entry. The turnpiece will rotate but will not activate passage mode. User code or key will always be required for entry. 1. Make sure the door is open. 2. If you have not enabled a programming code, press and release the program button. You will hear two beeps. If you have enabled a programming code, enter your programming code, then press Kwikset. You will hear one short beep and the keypad will flash green. 3. Press 9. You will hear one long beep and the keypad will flash green. 4. Press Kwikset. You will hear one long beep and the keypad will flash green if successful. If you hear three beeps and the keypad flashes red, it was unsuccessful. Repeat from Step 1.
Read MoreRemove and reinstall the lock, making sure that the tailpiece is horizontal in steps 4 and 5 here.
Read MoreEnter your PC, then re-enter the door handing code: Press "Kwikset" then "0" then "Kwikset"
Read MoreEnter your Programming Code. Press enter arrow. You will hear one beep. Press 0. Press enter arrow. You will hear two beeps. The latch bolt will extend and retract to learn the orientation of the door. If successful, you will hear 2 beeps. If unsuccessful, you will hear 3 beeps (make sure the door is open and unlocked and that you are using a fresh set of batteries).
Read MoreHow to set a locking and unlocking direction? To activate the screen, touch screen with palm or back of hand until digits illuminate. While the door is OPEN and UNLOCKED, activate the screen. Enter the following code to teach the lock the orientation of the door: Enter your programming code. Press enter arrow. You will hear one beep. Press 0. Press enter arrow. The latch bolt will extend and retract. If successful, you will hear 2 beeps. If unsuccessful, you will hear 3 beeps. If batteries are low, you will hear 10 beeps. If unsuccessful, make sure the door is unlocked and that you are using a fresh set of batteries. If successful, activate the screen. Press the Lock symbol. The latch bolt will extend to lock. Activate the screen. Touch the random digits that appear (this is a security feature that ensures fingerprints are spread around the entire screen). Enter the default User Code (1-2-3-4), then press the Lock symbol. The door will unlock.
Read MoreSet Locking and Unlocking Direction What is the location of the latch? For left-Locking Latch (If bolt goes left): Press and release PROG. You will hear 2 long beeps. Press lock button Press 1-2 button Press PROG. You will hear 1 long beep. If not, repeat the process from step A. For right-Locking Latch (If bolt goes right): Press and release PROG. You will hear 2 long beeps. Press lock button Press 5-6 button Press PROG. You will hear 1 long beep. If not, repeat the process from step A.
Read MoreThe hole in the door frame behind the strike is NOT drilled at least 1 in (25 mm) deep. Make sure the hole in the door frame behind the strike is drilled at least 1 in (25mm) deep. The strike plate is NOT aligned with the latch bolt. Make sure the strike plate is aligned with the latch bolt. If needed, reposition the strike.
Read More