Skip to Main Content

Home / Support / Levers / Sydney Lever (Round) - Keyed

Support

Sydney Lever (Round) - Keyed

Discontinued

Finishes

Satin Nickel

Ask A Question Register Product

Documents

Note: Do not use prints from this website to mark distances. Due to individual printers, dimensions on installation instructions may not print at an accurate scale.

Installation Guide

6.1 MB

Answers

Support answers found: 5

Choose a Topic

Installation & Prep

Answer
My lever falling off, how do I fix this?

If you are experiencing the lever falling off, the set screw is still in the shaft. If you remove the lever and on one side of the shaft there is a hole and the other side there is a silver button. That silver button is the set screw. Place the lever back on to the shaft, using a 3/32 hex wrench tighten the screw through the lever and shaft.
Read More
Answer
How do I tighten the screws for my lever that has concealed screws?

This model is a lever and requires a 3/32 Allen wrench to remove the handle in order to pop the rose plate off and expose the screws.
Read More
Answer
What is the part number for my lever set screws?

The set screws #83254 for the levers.
Read More
Answer
How can the reversible lever work on both a left hand, and a right hand configured door?

The "Reversible Lever" function allows you to install the leverset on either a left hand, or a right hand configured door. The interior lever can be removed from the rosette assembly and switched with the exterior lever. This prevents the levers from being upside down when installation is complete.
Read More
Answer
How do I reverse my mechanical lever?

To reverse the handing of your levers, insert a flat head screwdriver into the lever catch. Remove both levers away from the chassis. Exchange each side with the other. Snap each lever on the corresponding side of the chassis.
Read More

Community Q&As